Base cleaner and cloth
Level work station
1. Clean It Up
The first step is to clean your base. You want to get all that grime off so the wax really takes. You can either use base cleaner and a rag or, to take the more involved route, run a hot iron over the base, apply a thin layer of wax, and scrap instantly. The “hot scrape” technique cleans your base by opening the pores and allowing any muck that might be hiding in there to be pulled out. Keeping your base clean might not be as much of an issue in the winter, but come spring and summer there’s a lot of contaminants in the snow, so a good base cleaning is crucial
2. Loosen Up
It’s a good idea to loosen the bolts on your board. Reason is, the bolts conduct heat when you run the iron over them and then create small dimples in your base. You don’t have to remove them entirely, just loosen them a little so you’re waxing a nice level base.
3. Get To Waxing
This is where you’ve got some decisions to make. First, choose a wax that best suits the conditions (e.g., temperature) you’re shredding in. You can never go wrong with a good all-temp wax. When applying wax keep in mind that your edge is the section of base that takes the most abuse, so it’s smart to use a harder wax along your edges. There are a couple different application techniques, but the idea is the same. You want an even coat of wax across the base.